8/10-3
Eksport: 
PDF
PDF-
Generell informasjon
-
Brønnhistorie
GeneralWell 8/10-3 was drilled on the Megalodon prospect in the western part of Norwegian-Danish Basin in the southern North Sea. The objective was to test the pre-Zechstein play potential of the Rotliegendes sandstone (Auk Formation equivalent) in relation to a potential Carboniferous source. The evaporites of the Upper Permian Zechstein Group form an effective top seal. The Megalodon well was planned as a vertical HPHT well with an anticipated dry hole TD of 5600 m.Operations and resultsWildcat well 8/10-3 was spudded with the jack-up installation Mærsk Galant on and drilled to TD at 5737 m in sandstone of the Permian Rotliegendes Group. A 12 1/4" pilot hole was drilled from 261 to 1061 m to check for shallow gas. A notable formation gas peak of 7.7% (C1 only) occurred at 566m in a thick sand unit. This correlated with a shallow gas anomaly identified on the site survey 67 m from the well position. The well was drilled with seawater and sweeps down to 216 m, with spud mud and NaCl water based mud from 216 m to 1100 m, with Versatec oil based mud from 1100 m to 3452 m, and with Paratherm oil based mud from 3452 m to TD.The well was dry at the Rotliegendes target. No specific secondary target had been identified, however, due to the position of the well on top of a salt diapir, 4-way dip closures were drilled through at several levels from Paleocene to Top Zechstein. No hydrocarbons were found here. Sandstone and siltstone were penetrated in the Triassic, Skagerrak and Smith Bank Formation. Above this, the Jurassic Mandal, Farsund and Sandnes Formation were penetrated without sand.The Rotliegendes Group, penetrated at 5397.5 m, came in 56.5 m low to prognosis, under 2003 m of Zechstein salt and carbonates. The uppermost 192m of the Rotliegendes consisted of shales interbedded with argillaceous sandstones, overlying 154 m of well developed Auk Formation Equivalent sandstones with interbedded shales. Dead oil and tarry oil stains were observed in sandstones at several depths often confined to the upper parts of the sandstone beds. The reservoir properties of the sandstones are good, with porosities averaging 18% and a net-to-gross of 77%. Three pressure points were obtained in the lower sandstone unit using the XPT tool. These indicate permeabilities in the 2 - 4 mD range.No cores were cut and no wire line fluid samples were taken.The well was permanently abandoned on 6 October 2010 as a dry well.TestingNo drill stem test was performed. -
Borekaks i Sokkeldirektoratet
Borekaks i Sokkeldirektoratet Borekaks tilgjengelig for prøvetaking?YESBorekaks i Sokkeldirektoratet Borekaksprøve, topp dybde [m]Borekaksprøve, bunn dybde [m]220.005738.00 -
Litostratigrafi
Litostratigrafi Topp Dyb [mMD RKB]Litostrat. enhet11414162372237223972422252725502556255626212743289828982927295030093077307730903099309931583221339453975398 -
Logger
Logger Type loggTopp dyp for logg [m]Bunn dyp for logg [m]MWD - DIR113216MWD - DIR2161100MWD - RLL GR RES PWD DIR2161061MWD - RLL GR RES PWD DIR30233452MWD - RLL GR RES PWD GEOTAP DIR53505575MWD - RLL GR RES PWD SON DIR34525350QAIT QSLT QTGC1135743XPT-H55995612 -
Foringsrør og formasjonsstyrketester
Foringsrør og formasjonsstyrketester Type utforingUtforing diam.
[tommer]Utforing dybde
[m]Brønnbane diam.
[tommer]Brønnbane dyp
[m]LOT/FIT slam eqv.
[g/cm3]Type formasjonstestCONDUCTOR30208.036216.00.00LOTPILOT HOLE1061.012 1/41061.00.00LOTSURF.COND.201080.0261100.01.73LOTINTERM.13 5/83447.017 1/23452.02.15LOTINTERM.9 5/85245.012 1/25350.02.15LOTOPEN HOLE5738.08 1/25738.00.00LOT -
Boreslam
Boreslam Dybde MD [m]Egenvekt, slam [g/cm3]Viskositet, slam [mPa.s]Flytegrense [Pa]Type slamDato, måling2161.054.0Spud Mud5101.107.0Spud Mud7301.6134.0Versatec8901.136.0Spud Mud9801.2216.0NACl Brine10881.2515.0NACl Brine11001.4334.0Versatec11901.4338.0Versatec26461.5844.0Versatec30231.5541.0Versatec34521.6155.0Versatec40051.9752.0Paratherm53501.9435.0Paratherm54661.9452.0Paratherm55521.7926.0Paratherm57381.7736.0Paratherm