35/2-2
Eksport: PDF
-
Generell informasjon
-
Brønnhistorie
GeneralWell 35/2-2 was drilled to appraise the Peon discovery on the Tampen Spur about one block west of the Agat discovery in the northern North Sea. The objectives were to establish reservoir properties and test the hydrocarbon potential of the Peon structure, verify Sandaband as a barrier for the production wells, and test gravel pack as completion design for future production wells. Other objectives for the well were to get further information about stress in the overburden, reservoir and underburden, acquire sonic and density data from the overburden 40m over the reservoir, and collect water samples.Operations and resultsAppraisal well 35/2-2 was spudded with the semi-submersible installation Transocean Winner on 2 June 2009 and drilled to TD at 640 m in Pliocene sediments of the Naust Formation. The seabed temperature was measured by two seabed memory gauges provided by Oceaneering. The seabed temperature oscillated between 5.8 to 6.7 deg C. An average of 6.3 deg C was taken as the seabed temperature. The well was drilled with seawater down to 429 m, with Sildril mud from 429 m to 571 m, and with Glydril Mud from 571 m to TD.The geological model of Peon was confirmed by the well 35/2-2 and its technical sidetrack. Gas was encountered as expected from 580 down to a gas-water contact at 594 m in the Naust Formation "Peon sand". The gas is 99.98% methane with a carbon isotopic composition proving a biogenic origin. No oil shows were observed. A full set of wire line logs was acquired over the reservoir section; including sampling of a good quality water sample at 601 m. Sonic data was acquired in the overburden; however shear data is only available in the 8-1/2" section. Stress tests and extended leak-off tests were not done after careful consideration during risk assessments. Gravel pack as completion solution worked as expected. Unfortunately, Sandaband could not be pumped in the well and could therefore not be tested as a barrierA core in the upper part of the reservoir was planned with the Full Closure Core Catcher", but not taken as the equipment did not work according to specifications.The well was permanently abandoned on 26 July as a gas appraisal well.TestingThe gas reservoir was tested with a full scale DST. The test was performed from a technical sidetrack (35/2-2 T2) drilled down to 592 m, 2 m above the gas-water contact. The test produced as expected a gas rate of 1200000 Sm3/day on a 120/64" choke size. At top reservoir the formation pressure was measured to 59.7 bars at 581m TVD RKB. The temperature recorded in the DST was 11.8 deg C, but is believed to be lower than the formation temperature due to gas expansion effects. Based also on temperatures from the MDT measurements a temperature of 12.5 deg C is taken as the Formation temperature at the top of the reservoir, 581 m. -
Borekaks i Sokkeldirektoratet
Borekaks i Sokkeldirektoratet Borekaks tilgjengelig for prøvetaking?YESBorekaks i Sokkeldirektoratet Borekaksprøve, topp dybde [m]Borekaksprøve, bunn dybde [m]543.00640.00 -
Palynologiske preparater i Sokkeldirektoratet
Palynologiske preparater i Sokkeldirektoratet Prøve dybdeDybde enhetPrøve typeLaboratorie543.0[m]DCFUGRO549.0[m]DCFUGRO552.0[m]DCFUGRO555.0[m]DCFUGRO558.0[m]DCFUGRO561.0[m]DCFUGRO564.0[m]DCFUGRO567.0[m]DCFUGRO570.0[m]DCFUGRO573.0[m]DCFUGRO576.0[m]DCFUGRO579.0[m]DCFUGRO582.0[m]DCFUGRO585.0[m]DCFUGRO588.0[m]DCFUGRO591.0[m]DCFUGRO592.0[m]DCFUGRO594.0[m]DCFUGRO597.0[m]DCFUGRO600.0[m]DCFUGRO603.0[m]DCFUGRO606.0[m]DCFUGRO609.0[m]DCFUGRO612.0[m]DCFUGRO615.0[m]DCFUGRO618.0[m]DCFUGRO621.0[m]DCFUGRO624.0[m]DCFUGRO627.0[m]DCFUGRO630.0[m]DCFUGRO633.0[m]DCFUGRO636.0[m]DCFUGRO639.0[m]DCFUGRO640.0[m]DCFUGRO -
Litostratigrafi
Litostratigrafi Topp Dyb [mMD RKB]Litostrat. enhet398398 -
Borestrengtester (DST)
Borestrengtester (DST) Test nummerFra dybde MD
[m]Til dybde MD
[m]Reduksjonsventil størrelse
[mm]1.058160048.0Borestrengtester (DST) Test nummerEndelig avstengningstrykk
[MPa]Endelig strømningstrykk
[MPa]Bunnhullstrykk
[MPa]Borehullstemperatur
[°C]1.03.8005.30012Borestrengtester (DST) Test nummerOlje produksjon
[Sm3/dag]Gass produksjon
[Sm3/dag]Oljetetthet
[g/cm3]Gasstyngde rel. luftGOR
[m3/m3]1.01200000 -
Logger
Logger Type loggTopp dyp for logg [m]Bunn dyp for logg [m]ECS TLD398543EMS370500EMS405568EMS405569FMI564592FMI654637IBC390418IBC CBL400503IBC CBL400539IBC CBL400565IBC CBL445542MDT581607MDT601602MDT601601MFC-60375530MWD LWD - PP ARC RES9429640PEX443568PEX564592PEX HRLA564637PPC GPIT MSIP564637 -
Foringsrør og formasjonsstyrketester
Foringsrør og formasjonsstyrketester Type utforingUtforing diam.
[tommer]Utforing dybde
[m]Brønnbane diam.
[tommer]Brønnbane dyp
[m]LOT/FIT slam eqv.
[g/cm3]Type formasjonstestCONDUCTOR30429.036429.00.00LOTSURF.COND.13 3/8539.017 1/2543.01.20LOTINTERM.9 5/8564.012 1/4571.01.22LOTOPEN HOLE640.08 1/2640.00.00LOT -
Boreslam
Boreslam Dybde MD [m]Egenvekt, slam [g/cm3]Viskositet, slam [mPa.s]Flytegrense [Pa]Type slamDato, måling4291.5020.0SILDRILL5431.1210.0SILDRILL5631.1319.0Glydril5711.1315.0Glydril6401.1316.0Glydril6401.1316.0Glydril