24/9-5
Eksport: PDF
-
Generell informasjon
-
Brønnhistorie
GeneralWildcat well 24/9-5 was drilled in a location SW of the Heimdal field, ca 5 km from the UK border. It was programmed to test two primary sandstone prospects in the Late Paleocene. The lower objective was the Hermod Formation and the upper objective was sandstones within the Balder Formation. The Hermod Formation prospect was a mapped isochron thick with a small area of structural closure at Top Sele Formation. The Balder Formation prospect was mapped as an isochron thick with an associated seismic amplitude anomaly and was primarily regarded as a stratigraphic trap.Operations and resultsWildcat well 24/9-5 was spudded with the semi-submersible installation West Delta on 7 December 1993 and drilled to TD at 2860 m in the Late Cretaceous Jorsalfare Formation. No significant problem was reported from the operations. The well was drilled with seawater down to 581 m, with KCl/PAC/PHPA from 581 m to 1941 m, and with KCl/PAC/PHPA/glycol from 1941 m to TD.The Balder Formation was encountered at 1964 m. A gross oil bearing Intra Balder Formation sandstone interval of 7.1 m was encountered at 2011 m. Net sandstone was 6.3 m of which 5.9 m was in a single massive unit. Petrophysical analysis gave porosities of 35 - 40% in the massive sandstone unit with an average SW of 22.2%. Base of the reservoir was encountered at 2018 m, which was found to be an oil-down-to water contact. Samples from the FMT tool indicated the reservoir fluid to consist of 32-34 deg API oil with a GOR of 91 Sm3/Sm3. Pressure gradient analysis gave a free water level at 2031.5 m (2028.0 m TVD). Geochemical analysis of the oil sample indicated minor biodegradation had taken place. The Sele Formation was encountered at 2031 m with 47 m net sandstone in two Hermod Formation sequences. The upper sequence was encountered at 2049 m and the lower at 2098 m. These sandstones proved to be water bearing with no shows. A thin sandstone at 2045.5 - 2047 m, just above the upper Hermod interval, gave the highest known water below the Balder Formation pay interval. An additional zone of interest was encountered in the interval 1775-1790 m where a number of siltstone/argillaceous sandstone stringers were identified. Minor gas shows were observed and rare traces of sandstone gave poor (residual?) oil shows. Log analysis showed the presence of hydrocarbons in thin argillaceous stringers particularly over the interval 1785-1787.5 m where neutron density logs (acquired through casing) indicated the presence of gas (Average SW = 40%).Four conventional cores were cut. Three were cut in the Late Palaeocene Balder Formation with 7 m Intra Balder Formation sandstone. The fourth was cut in the Hermod Formation Sandstone within the Sele Formation. Three FMT samples were taken in the well, one at 2013.5 m (oil) and two at 2017.5 m (mud filtrate)Although the hydrocarbon-bearing interval in the Balder Formation was as prognosis it was recognised that the well was not in an optimum location and it was decided to drill an immediate appraisal well. Well 24/9-5 was therefore not tested.The well was permanently abandoned on 26 January 1994 as an oil discovery.TestingNo drill stem test was performed in the well. -
Borekaks i Sokkeldirektoratet
Borekaks i Sokkeldirektoratet Borekaks tilgjengelig for prøvetaking?YESBorekaks i Sokkeldirektoratet Borekaksprøve, topp dybde [m]Borekaksprøve, bunn dybde [m]590.002860.00 -
Borekjerner i Sokkeldirektoratet
Borekjerner i Sokkeldirektoratet Kjerneprøve nummerKjerneprøve - topp dybdeKjerneprøve - bunn dybdeKjerneprøve dybde - enhet12000.02001.8[m ]22002.52019.9[m ]32020.32033.1[m ]42048.32052.8[m ]Borekjerner i Sokkeldirektoratet Total kjerneprøve lengde [m]36.5Borekjerner i Sokkeldirektoratet Kjerner tilgjengelig for prøvetaking?YES -
Kjernebilder
-
Litostratigrafi
Litostratigrafi Topp Dyb [mMD RKB]Litostrat. enhet1513605505556951203125512941309196419642011201820312049208220982112211621612624272828282828 -
Spleisede logger
Spleisede logger Dokument navnDokument formatDokumentstørrelse [MB]pdf0.36 -
Geokjemisk informasjon
Geokjemisk informasjon Dokument navnDokument formatDokumentstørrelse [MB]pdf1.88 -
Dokumenter – rapportert av utvinningstillatelsen (frigitt ihht til regelverk)
Dokumenter – rapportert av utvinningstillatelsen (frigitt ihht til regelverk) Dokument navnDokument formatDokumentstørrelse [MB]pdf17.34 -
Logger
Logger Type loggTopp dyp for logg [m]Bunn dyp for logg [m]ACBL129574ACBL4501344BRIDGEPLUG BST CCL17001806CBL VDL GR10101932CDL CN GR CAL17502858DIFL ACL SP GR CAL1291362DIFL ACL SP GR CAL13441881DIFL ACL SP GR CAL19322859DLL MLL SL CAL SP19302350FMT VPC GR20112320FMT VPC GR20122012FMT VPC GR20122111FMT VPC GR20172017HDIP GR19322350MWD LWD - GR DPR1592834SWC PFC19502657VSP5002850 -
Foringsrør og formasjonsstyrketester
Foringsrør og formasjonsstyrketester Type utforingUtforing diam.
[tommer]Utforing dybde
[m]Brønnbane diam.
[tommer]Brønnbane dyp
[m]LOT/FIT slam eqv.
[g/cm3]Type formasjonstestCONDUCTOR30235.036240.00.00LOTSURF.COND.20576.026581.00.00LOTINTERM.13 3/81346.017 1/21377.00.00LOTINTERM.9 5/81935.012 1/21941.00.00LOTOPEN HOLE2860.08 1/22860.00.00LOT -
Boreslam
Boreslam Dybde MD [m]Egenvekt, slam [g/cm3]Viskositet, slam [mPa.s]Flytegrense [Pa]Type slamDato, måling2401.2015.0WATER BASED5801.25100.0WATER BASED11241.1718.0WATER BASED13771.2523.0WATER BASED13771.2220.0WATER BASED22031.2523.0DUMMY28601.2521.0DUMMY -
Trykkplott
Trykkplott Porertrykksdataene kommer fra logging i brønnen hvis ingen annen kilde er oppgitt. I noen brønner der trykk ikke er logget, er det brukt informasjon fra formasjonstester eller brønnspark. Trykkdataene er rapportert inn til Oljedirektoratet og videre prosessert og kvalitetssikret av IHS Markit.Trykkplott Dokument navnDokument formatDokumentstørrelse [MB]pdf0.21