25/8-12 A
Eksport: PDF
-
Generell informasjon
-
Brønnhistorie
GeneralWell 25/8-12 A is a sidetrack from well 25/8-12 S, which encountered oil in Lower Jurassic, Upper Statfjord Formation sandstones. It was drilled to appraise the southern extension of the 25/8-11 Ringhorn discovery. In the Ringhorn structure, the BCU is also the base of the chalk and represents the overall top of the Lower Jurassic reservoir interval. The primary objective for well 25/8-12 A was Lower Statfjord Formation sandstones, in an eroded horst, fault block.Operations and resultsAppraisal well 25/8-12 A was drilled with the semi-submersible installation "Mærsk Jutlander". It was kicked of from 1014 m in the 8 1/2" section of 25/8-12 S on June 9, 1999 and drilled to TD at 2156 m in the Triassic Smith Bank Formation. The wellbore was drilled with oil based "Environment" mud. Top Statfjord Formation was found at 1945.7 m (1863.1 m TVD SS). Oil was encountered in Lower Statfjord Formation sandstones, as prognosed. Pressures and fluid sampling was undertaken with Schlumberger's Modular Dynamic Tester (MDT). Pressure measurements gave an oil gradient of 0.0719 bars/m (0.318 psi/ft), consistent with the oil gradient in the original 25/8-12 S wellbore (0.0749 bars/m) and in the 25/8-11 well (0.0741 bars/m). The oil and water gradients intersect to give an OWC at 1917.5 m TVD SS (2005 m MD RKB), in agreement with the Free Water Level defined in the 25/8-11. The deepest sands in the wellbore, the water bearing sands below 1970 m TVD SS, appear to record a separate, higher reservoir gradient. Four oil samples were collected in 450 cc MDT chambers at 1975 m, within the main Jurassic sand reservoir. No draw down was seen during the sampling. Temperature (measured, not static) ranged from 78.4 deg C to 79.3 deg C during the sampling. In addition to the 450 cc chambers, a single one-gallon chamber was filled with oil at the same depth. A one-gallon water sample was obtained at 2008.2 m. One core was cut in the interval 1951 - 1988.5 in the Statfjord Formation. Well 25/8-12 A was permanently abandoned on June 19 1999 as an oil appraisal well.TestingNo drill stem test was performed -
Borekaks i Sokkeldirektoratet
Borekaks i Sokkeldirektoratet Borekaks tilgjengelig for prøvetaking?YESBorekaks i Sokkeldirektoratet Borekaksprøve, topp dybde [m]Borekaksprøve, bunn dybde [m]1600.002156.00 -
Borekjerner i Sokkeldirektoratet
Borekjerner i Sokkeldirektoratet Kjerneprøve nummerKjerneprøve - topp dybdeKjerneprøve - bunn dybdeKjerneprøve dybde - enhet11951.01988.5[m ]Borekjerner i Sokkeldirektoratet Total kjerneprøve lengde [m]37.5Borekjerner i Sokkeldirektoratet Kjerner tilgjengelig for prøvetaking?YES -
Kjernebilder
-
Palynologiske preparater i Sokkeldirektoratet
Palynologiske preparater i Sokkeldirektoratet Prøve dybdeDybde enhetPrøve typeLaboratorie1948.0[m]DCRRI1951.0[m]DCRRI1958.0[m]DCRRI2002.0[m]DCRRI2014.0[m]DCRRI2020.0[m]DCRRI2032.0[m]DCRRI -
Litostratigrafi
Litostratigrafi Topp Dyb [mMD RKB]Litostrat. enhet15056067272872895411551166174817481815187519151921194620282028 -
Spleisede logger
Spleisede logger Dokument navnDokument formatDokumentstørrelse [MB]pdf0.39 -
Dokumenter – rapportert av utvinningstillatelsen (frigitt ihht til regelverk)
Dokumenter – rapportert av utvinningstillatelsen (frigitt ihht til regelverk) Dokument navnDokument formatDokumentstørrelse [MB].pdf2.04.pdf76.15 -
Logger
Logger Type loggTopp dyp for logg [m]Bunn dyp for logg [m]AIT-H DSI IPLT GR9862160MDT GR19482064MWD - DIR153213MWD - EWR4 DGR2132156VSP3002150 -
Foringsrør og formasjonsstyrketester
Foringsrør og formasjonsstyrketester Type utforingUtforing diam.
[tommer]Utforing dybde
[m]Brønnbane diam.
[tommer]Brønnbane dyp
[m]LOT/FIT slam eqv.
[g/cm3]Type formasjonstestCONDUCTOR30211.036213.00.00LOTINTERM.9 5/8990.012 1/4990.00.00LOTOPEN HOLE2156.08 1/22156.01.62LOT -
Boreslam
Boreslam Dybde MD [m]Egenvekt, slam [g/cm3]Viskositet, slam [mPa.s]Flytegrense [Pa]Type slamDato, måling8251.3230.0OIL (ENVIRON)8601.3330.0OIL (ENVIRON)13401.3230.0OIL (ENVIRON)21561.3227.0OIL (ENVIRON) -
Trykkplott
Trykkplott Porertrykksdataene kommer fra logging i brønnen hvis ingen annen kilde er oppgitt. I noen brønner der trykk ikke er logget, er det brukt informasjon fra formasjonstester eller brønnspark. Trykkdataene er rapportert inn til Oljedirektoratet og videre prosessert og kvalitetssikret av IHS Markit.Trykkplott Dokument navnDokument formatDokumentstørrelse [MB]pdf0.20