6506/9-1
Eksport: PDF
-
Generell informasjon
-
Brønnhistorie
GeneralWell 6506/9 ‐ 1 was drilled to further evaluate the Victoria discovery. The discovery was proven by well 6506/6-1 in 2000 in Lower to Middle Jurassic reservoir rocks, and is located about 22 kilometres northwest of the Heidrun field in the Norwegian Sea.The objective was to reduce uncertainties on fluid contacts, reservoir structure and reservoir quality, to prove well productivity and obtain reliable fluid samples from the Garn, Ile, Tilje and Åre reservoirs of Victoria.Operations and resultsAppraisal well 6506/9 ‐ 1 was spudded with the semi-submersible installation West Phoenix on 20 January 2009 and drilled to TD at 5664 m in the Early Jurassic Åre Formation. The well was drilled without significant problems, although wire line logging and sampling at TD was problematic due to high temperatures. The well was drilled with spud mud down to 1510 m, with NABM (non-aqueous based, or oil based mud) from 1510 to 5022 m, and with WARP (Weight Additive Research Project) NABM mud from 5022 m to TD.All the reservoirs were drilled in the 8 1/2" section, and confirmed to be gas bearing. However, reservoirs characteristics were poor, except in a few metric layers. The Garn Formation (5212 to 5277 m) was composed of very tight sandstones with quartzite cement. Maximum gas shows were 2.2% total gas at 5232 m. In the Ile Formation the gas shows were quite constant along the whole formation with limited values due to the coring operations. Maximum values in porous layers were between 1.35 and 3.52 % total gas. In the Tilje Formation, the overall reservoir characteristics were better with a maximum of 5.84% total gas at 5488m. At the base of the Tilje, below 5534 m, formation gas decreased to less than 1% total gas, linked to reservoir characteristics decrease. The Åre Formation consisted of mainly siltstonesand silty claystones with poor reservoir characteristics in its upper part (maximum 1.68% TG). The lower half of the Åre Formation, composed of very hard poorly sorted sandstones, had very poor reservoir characteristics. Maximum gas show was 3.85% total gas at 5653m.Petrophysical analysis showed that the Jurassic reservoirs Garn, Ile, Tofte, Tilje and Åre were all gas bearing with a total Net to Gross of 18%, corresponding to 81m of Net. The effective porosity average in the Net interval was 12.4 %. Both Ile and Tilje Formations were encountered in a Gas ‐ Down ‐ To/Water ‐ Up ‐ To configuration. The Ile Formation has GDT at 5297 m and WUT at 5325 m. The Tilje Formation had GDT at 5515 m and WUT at 5523 m. No oil shows were reported from the well.Five cores were acquired in the Ile, Tilje and Åre Formations. The Ile Formation (5294 m to 5358 m) was nearly entirely cored. The Tilje Formation (5435 m to 5572 m) was cored from 10 m below the top of Tilje Formation when gas bearing sandstones were confirmed. The Åre Formation (5572 m to well TD) was cored in its upper section, represented mainly by siltstones and silty claystones, with poor reservoir characteristics (maximum 1.68% total gas).Wire line logging was performed to evaluate the different reservoirs. After one run in 12 1/4" section, a total of 20 runs were performed in the 8 1/2" section for reservoir evaluation, formation pressure measurement and sampling. Due to the high temperature expected at Victoria well TD, a series of special MDT tools, capable to work at 210 deg C, were prepared in the framework of a R&D project between TOTAL and Schlumberger to obtain formation pressure measurements and fluid samples. Although repeated attempts were done, the performances were poor due to low permeability reservoir and tool failures. Fluid samples of questionable quality were obtained at four depths: 5294.8 m (dry gas contaminated by base oil), 5341.7 m (base oil, some gas, and a few ml of water), 5479.0 m (mud, base oil and some gas), and at 5538.5 m (mud filtrate and small volumes of water - no trace of gas)The well was permanently abandoned on 15 September 2009 as a gas appraisal well.TestingThe well was perforated in Upper and Middle Tilje (5431 m ? 5515 m) and a successful DST was carried out. The maximum production rate was 180 000 Sm3/day through a 16/64-inch nozzle. On average the well produced ca 170 000 Sm3 gas and 15 - 20 Sm3 water day. The average gas composition roughly recorded during the test was 88% methane, 11% CO2, and ca 30 ppm H2S. No trace of condensate was seen. No temperature measurement is available from the test. -
Borekaks i Sokkeldirektoratet
Borekaks i Sokkeldirektoratet Borekaks tilgjengelig for prøvetaking?YESBorekaks i Sokkeldirektoratet Borekaksprøve, topp dybde [m]Borekaksprøve, bunn dybde [m]1510.005664.00 -
Borekjerner i Sokkeldirektoratet
Borekjerner i Sokkeldirektoratet Kjerneprøve nummerKjerneprøve - topp dybdeKjerneprøve - bunn dybdeKjerneprøve dybde - enhet15289.05316.6[m ]25316.65353.2[m ]35446.85501.7[m ]45502.05530.8[m ]55531.05613.8[m ]Borekjerner i Sokkeldirektoratet Total kjerneprøve lengde [m]230.7Borekjerner i Sokkeldirektoratet Kjerner tilgjengelig for prøvetaking?YES -
Litostratigrafi
Litostratigrafi Topp Dyb [mMD RKB]Litostrat. enhet45545515661909190919831983205921192119227625473059305931334548457545754650521252125277529453585358538554355572 -
Spleisede logger
Spleisede logger Dokument navnDokument formatDokumentstørrelse [MB]pdf0.81 -
Borestrengtester (DST)
Borestrengtester (DST) Test nummerFra dybde MD
[m]Til dybde MD
[m]Reduksjonsventil størrelse
[mm]1.0543155156.3Borestrengtester (DST) Test nummerEndelig avstengningstrykk
[MPa]Endelig strømningstrykk
[MPa]Bunnhullstrykk
[MPa]Borehullstemperatur
[°C]1.027.00040.000Borestrengtester (DST) Test nummerOlje produksjon
[Sm3/dag]Gass produksjon
[Sm3/dag]Oljetetthet
[g/cm3]Gasstyngde rel. luftGOR
[m3/m3]1.0180000 -
Logger
Logger Type loggTopp dyp for logg [m]Bunn dyp for logg [m]CALI4524911LWD - DIR455564LWD - GR RES PWD DIR5645664PO PQ HY PO LFA MS SC PC HTC EDT52945294PPC HDSI GPIT HLDS HAPS GR ECRI4555010PPC HDSI PPC HNGS RDTC ECRI50065662PQ HY PO SC MS GR ECRI53415538PQ HY PO SC MS GR ECRI53415341QAIT QSLT HTGC ECRI50065663QAST-VSP5115575QLDT QCNT GR ECRI50065665QSLT EDTC HTCS ECRI35354989SC PA PO MS GR ECRI54795539XPT HGR ECRI55385605XPT HTGC ECRI52945541XPT HTGC ECRI52945655 -
Foringsrør og formasjonsstyrketester
Foringsrør og formasjonsstyrketester Type utforingUtforing diam.
[tommer]Utforing dybde
[m]Brønnbane diam.
[tommer]Brønnbane dyp
[m]LOT/FIT slam eqv.
[g/cm3]Type formasjonstestCONDUCTOR30558.036564.00.00LOTSURF.COND.201501.0261510.00.00LOTINTERM.13 3/83532.0163555.00.00LOTINTERM.9 7/85009.012 1/45022.01.96LOTLINER75562.08 1/25564.00.00LOT -
Boreslam
Boreslam Dybde MD [m]Egenvekt, slam [g/cm3]Viskositet, slam [mPa.s]Flytegrense [Pa]Type slamDato, måling4951.0310.0ManualEntry6651.6051.0ManualEntry12821.216.0ManualEntry15001.3011.0ManualEntry15101.30ManualEntry18841.6046.0ManualEntry23341.8974.0ManualEntry27891.6046.0ManualEntry33551.6039.0ManualEntry36231.8056.0ManualEntry39261.8044.0ManualEntry41391.8349.0ManualEntry47741.8749.0ManualEntry47801.7410.0ManualEntry50221.7147.0ManualEntry50661.7036.0ManualEntry52891.7038.0ManualEntry53081.7410.0ManualEntry53851.7410.0ManualEntry55021.7045.0ManualEntry55601.7064.0ManualEntry56641.7710.0ManualEntry