25/8-13
Export: PDF
-
General information
-
Wellbore history
GeneralWell 25/8-13 was drilled on Production License 027B, near the Ringhorne and Jotun fields. The primary targets were the Early Paleocene Ty and Heimdal Formation sands.Operations and resultsWildcat well 25/8-13 was spudded with the semi-submersible installation "West Alpha" on 31 October 2001 and drilled to TD at 2258 m in the Early Jurassic Statfjord Formation. The well was drilled with seawater and bentonite sweeps down to 1038 m and with "Versavert" oil based mud from 1038 m to TD.The Heimdal Formation sand was not developed in this well. The best reservoir sands were encountered in the Ty Formation from 2099 m to 2182.5 m and in the Statfjord Formation from 2235 m to TD. All reservoir sands in the well were found water bearing. An anomaly on the resistivity logs in the uppermost 3 m of the Ty reservoir section could indicate residual hydrocarbons in this interval, but this is not supported by other data and it is therefore believed that the anomaly is due to mud invasion from the OBM.Eleven pressure points were successfully collected with a TD MDT logging run in the Paleocene, Jurassic and Triassic. From this data it appears that the massive Ty Fm sands and the Jurassic Vestland Group lie on the same pressure gradient while the Statfjord sands are not in pressure communication, lying on a gradient at about 5 bars higher. No coring (sidewall or conventional) was undertaken in this well. No fluid samples were taken. The well was permanently abandoned on 20 November 2001 as a dry well.TestingNo drill stem test was performed. -
Cuttings at the Norwegian Offshore Directorate
Cuttings at the Norwegian Offshore Directorate Cuttings available for sampling?YESCuttings at the Norwegian Offshore Directorate Cutting sample, top depth [m]Cutting samples, bottom depth [m]1040.002276.00 -
Palynological slides at the Norwegian Offshore Directorate
Palynological slides at the Norwegian Offshore Directorate Sample depthDepth unitSample typeLaboratory1830.0[m]DCAPT1850.0[m]DCAPT1904.0[m]DCAPT1910.0[m]DCAPT1920.0[m]DCAPT1930.0[m]DCAPT1960.0[m]DCAPT1970.0[m]DCAPT1980.0[m]DCAPT1990.0[m]DCAPT2000.0[m]DCAPT2010.0[m]DCAPT2020.0[m]DCAPT2030.0[m]DCAPT2040.0[m]DCAPT2045.0[m]DCAPT2051.0[m]DCAPT2054.0[m]DCAPT2063.0[m]DCAPT2069.0[m]DCAPT2075.0[m]DCAPT2081.0[m]DCAPT2090.0[m]DCAPT2093.0[m]DCAPT2096.0[m]DCAPT2099.0[m]DCAPT2102.0[m]DCAPT2117.0[m]DCAPT2140.0[m]DCAPT2170.0[m]DCAPT2180.0[m]DCAPT2190.0[m]DCAPT2200.0[m]DCAPT2210.0[m]DCAPT2220.0[m]DCAPT2230.0[m]DCAPT2240.0[m]DCAPT2260.0[m]DCAPT2276.0[m]DCAPT -
Lithostratigraphy
Lithostratigraphy Top depth [mMD RKB]Lithostrat. unit14649958265665697018331833191519772073209921832183218822102237 -
Documents – reported by the production licence (period for duty of secrecy expired)
Documents – reported by the production licence (period for duty of secrecy expired) Document nameDocument formatDocument size [MB].pdf4.42.PDF0.67 -
Logs
Logs Log typeLog top depth [m]Log bottom depth [m]DSI CSI GR2952269MDT GR20332246MWD219219MWD - CDR GR2191038MWD - GR CDR CDN810382101MWD - GR CDR CDN820202075MWD - GR CDR CDN820802276 -
Casing and leak–off tests
Casing and leak–off tests Casing typeCasing diam.
[inch]Casing depth
[m]Hole diam.
[inch]Hole depth
[m]LOT/FIT mud eqv.
[g/cm3]Formation test typeCONDUCTOR30215.036215.00.00LOTSURF.COND.13 3/81030.017 1/21030.01.72LOTOPEN HOLE2276.012 1/42276.00.00LOT -
Drilling mud
Drilling mud Depth MD [m]Mud weight [g/cm3]Visc. [mPa.s]Yield point [Pa]Mud typeDate measured2191.03WBM6101.03WBM10381.03WBM10380.00OBM10721.3223.0OBM19971.3226.0SBM21011.3221.0SBM21321.3222.0SBM22761.3222.0OBM -
Pressure plots
Pressure plots The pore pressure data is sourced from well logs if no other source is specified. In some wells where pore pressure logs do not exist, information from Drill stem tests and kicks have been used. The data has been reported to the NPD, and further processed and quality controlled by IHS Markit.Pressure plots Document nameDocument formatDocument size [MB]pdf0.22