34/10-12
Export:
PDF

-
General information
-
Wellbore history
GeneralWell 34/10-12 was drilled on Tampen Spur in the North Sea close to the western side of the Gullfaks Fault Block. The primary objective of the well was to test sandstones of Middle Jurassic age. Secondary objectives were sandstones of Early Jurassic age.Operations and resultsWildcat well 34/10-12 was spudded with the semi-submersible installation Neptuno Nordraug on 16 July 1981 and drilled to TD at 2800 m in the Early Jurassic Statfjord Group. The well was drilled with seawater and prehydrated Gel pills down to 298 m and with gel/lignosulphonate mud from 298 m to TD.The sandstones of both Middle and Early Jurassic age were water saturated. Shows were recorded on cuttings from claystones, limestone and occasional thin sandstones from 1260 m in the Hordaland Group to 1657 m in the Balder Formation. The Jurassic had only trace fluorescence in sandstone cuttings at 2094 to 2110 m in the Ness Formation, otherwise no trace of hydrocarbons were seen.One core was cut from 2037 m to 2042.7 m in the Ness Formation. No wire line fluid samples were taken.The well was permanently abandoned on 12 September as a dry well.TestingNo drill stem test was performed. -
Cuttings at the Norwegian Offshore Directorate
Cuttings at the Norwegian Offshore Directorate Cuttings available for sampling?YESCuttings at the Norwegian Offshore Directorate Cutting sample, top depth [m]Cutting samples, bottom depth [m]230.002795.00 -
Cores at the Norwegian Offshore Directorate
Cores at the Norwegian Offshore Directorate Core sample numberCore sample - top depthCore sample - bottom depthCore sample depth - uom12037.02041.0[m ]Cores at the Norwegian Offshore Directorate Total core sample length [m]4.0Cores at the Norwegian Offshore Directorate Cores available for sampling?YES -
Core photos
-
Lithostratigraphy
Lithostratigraphy Top depth [mMD RKB]Lithostrat. unit16393310051633163316871807201420142176219822502250235024702688 -
Geochemical information
-
Documents – reported by the production licence (period for duty of secrecy expired)
Documents – reported by the production licence (period for duty of secrecy expired) Document nameDocument formatDocument size [MB]pdf1.67pdf20.70pdf0.44pdf4.72pdf5.69pdf2.09 -
Logs
Logs Log typeLog top depth [m]Log bottom depth [m]BGT GR2961560CBL VDL1501543CBL VDL GR CCL12001932FDC CNL GR CAL2252798GEODIP20102260HDT DIP19322784ISF SON GR SP1602795 -
Casing and leak–off tests
Casing and leak–off tests Casing typeCasing diam.
[inch]Casing depth
[m]Hole diam.
[inch]Hole depth
[m]LOT/FIT mud eqv.
[g/cm3]Formation test typeCONDUCTOR30223.036225.00.00LOTSURF.COND.20296.026306.01.30LOTLINER16865.022865.01.56LOTINTERM.13 3/81545.017 1/21560.01.74LOTINTERM.9 5/81934.012 1/41950.01.94LOTOPEN HOLE2800.08 1/22800.00.00LOT -
Drilling mud
Drilling mud Depth MD [m]Mud weight [g/cm3]Visc. [mPa.s]Yield point [Pa]Mud typeDate measured2501.0610.0WATER BASED3901.116.0WATER BASED8001.098.0WATER BASED14501.168.0WATER BASED18201.3812.0WATER BASED19551.6517.0WATER BASED23101.7017.0WATER BASED23901.7416.0WATER BASED -
Pressure plots
Pressure plots The pore pressure data is sourced from well logs if no other source is specified. In some wells where pore pressure logs do not exist, information from Drill stem tests and kicks have been used. The data has been reported to the NPD, and further processed and quality controlled by IHS Markit.Pressure plots Document nameDocument formatDocument size [MB]pdf0.22